top of page
OIL SKIMMER INTERCEPTION INTRODUCTION
Grease retention method is mainly applied different principles proportion of oil and water,
the proportion of different to make oil floating, separated from the water, while separating
the oil trapped in the tank plus ingredients to clear after. the oil components will no longer
flowing out polluting the environment.
The speed and the oil droplets rise of molecular particle diameter squared, water density
proportional to the difference, and inversely proportional to the viscosity of water.,
If oil particles floating in oil in water speed faster the separation, the higher efficiency.
So if the oil molecules particles increase, more oil floating rate may be doubled.
The industry, processing industry, food industry wastewater often with their very high
fat / oil content and residues and other ingredients, so the law stipulates that discharges
subject to pretreatment facility only after tapping into the sewer pipes. By comparing
the advantages and disadvantages of various oil-water separation methods, work space,
the investment cost, ease of operation, etc., by gravity separation method is the way to
deal with grease traps in high-oil-containing wastewater better choice in one way.
-
ARISING FROM THE INDUSTRIAL PROCESSING OF FLOATING OIL, TRAMP OIL, CHIPS AND PARTICULATE REMOVAL THAT NEEDS.
-
PRE-TREATMENT OF WASTE WATER AND PRECIPITATION TANK BEST SECTION DEVICE (ON DEMAND BY ENVIRONMENT DESIGN PLAN).
-
WHEN OIL AND WATER ARE TRANSPORTED BY FLOATING IN A WATER TANK AND OIL-WATER SUPPLY PUMP SUCTION UNIT, OCP-250 SEPARATOR FLOWS QUICKLY INTO THREE PHASES (OIL, WATER AND SOLIDS), SMALL MOLECULES CONDENSE INTO LARGE MOLECULES FLOATING TO SURFACE AFTER OIL REMOVAL, PARTICULATES IMPACT THROUGH T.P.M MODULE - OIL MOLECULES CONDENSE MEDIA FOCUSED BOARDS, PROVIDE WITH SEPARATE TINY OIL DROPLET COALESCENCE OF HIGH SURFACE AREA AS POSSIBLE.
-
THE OIL COALESCING INCREASING, OIL RISING TO THE SURFACE SO THE TRAMP OIL BY SEPARATING THE GRAVITY DISCHARGE. THE TREATED WATER (CLEAN) FLOW TO THE OUTLET TANK TO NATURAL PHYSICAL EMISSION.
-
HEAVY INFLOW OF SOLID PARTICLES SUSPENDED IN THE INLET TANK AND SETTLE DOWN FIRST, THEN IN THE SEPARATOR TANK OIL INCREASES WITH THE TILT ANGLE, ENABLING QUICK SETTLEMENT OF SUSPENDED PARTICLES, IN FAST-FLOWING WATER REMOVAL MACHINERY OIL OR TEMPORARILY DISPERSED OIL, AND PROCEDURE FOR THE SEPARATION TIME IS RELATIVELY SHORT, HIGHLY EFFICIENT.
-
SOLID SLUDGE SEDIMENTATION OF IMPURITIES IN THE BOTTOM OF THE TANK SHOULD BE CLEANED REGULARLY.
SPECIFICATION
FULPOW INDUSTRIAL CORP.,
Address:
7F-2, NO. 400, Sec. 1,Chang Ping Road,
Taichung 40652,Taiwan
TEL : +886 4 22439235
FAX : +886 4 22443829
E-Mail:fulpow@ms7.hinet.net
bottom of page